Lista 2023

Storage device settings:

  • Type: Location controlled
  • Manufacturer: Lista 2023
  • IP address and port number must be specified according physical connection to device

Module and location structure

  • No setup of modules and locations is needed from Admin Portal. Modules and locations are created via SFI (described further in this article).
  • One module corresponds to one drawer.
  • One location created for each lockable position of LPC drawer.
  • One location created for each LDC drawer. Additional locations for the LDC drawer can be created manually from AP or SFI.

Locations structure:

Configure new cabinet

To setup new cabinet, create new storage device on Admin Portal. Ensure, that Lista controller is connected to PC where SFI is installed and is accessible on IP address and port specified on the storage device. Once storage device is created, release and sync it to SFI.

 

On SFI, navigate to Stock management -> Manage Lista locations. If there are more cabinets of type Lista 2023, select cabinet to configure.

 

Option to manage Lista locations is visible only for users with SFI privilege to Setup locations

 

List of locations will be empty for newly created devices. Press Rescan configuration to obtain configuration from the cabinet.

Once configuration is obtained, list of all modules, their type (LPC or LDC) and number of locations in each module is shown. To create this structure, press Update modules. Confirm the change to proceed.

Once confirmed, cabinet is configured and ready to be used.

Update cabinet configuration

It is possible to update configuration of Lista 2023 cabinet in cases, when drawers are replaced with another type or cabinet extended. Updating the configuration will not affect any modules and locations, which remain unchanged – item assignments and physical quantities in those locations will remain intact.

 

When replacing drawer with different drawer of the same configuration (like in case of hardware failure), it is not needed to update configuration of the cabinet

 

To update configuration, proceed to Manage Lista locations as described during setup of a new cabinet. In list of current configuration, press Rescan configuration option.

If there is any difference between configuration currently available on SFI and configuration returned by cabinet, the configuration from the cabinet is shown with option to Update modules on SFI. Press the option and confirm the update to reflect any differences on SFI.

 

If module or location is not available anymore after the update, all items assigned in these locations are removed. Withdraw transaction is generated for any physical quantity in those locations

 

For modules and locations where no update is needed, assigned items remains unchanged. Custom names of modules or locations remains unchanged after the update.

Was this article helpful?

Related Articles

Contact Support

Can't find the answer you're looking for?
Email us